Guides
ProductDeveloperPartnerPersonal

Verify Umbrella with Meraki

You can verify the configuration and operation of Umbrella on your Meraki-administrated device.

Table of Contents

Prerequisites

Procedure

In the Meraki SM, your profile now has a new setting called “Umbrella DNS Proxy.”
This setting was pushed from the Umbrella dashboard.

890

Verify Local Operation on the iOS Device

Check the Meraki Profile.

  1. On your phone, tap Settings > General.
    The MDM profile is listed under Device Management.
169
  1. Tap Meraki Management.
    Verify that Web Content Filter is now listed. This is your confirmation that the updated profile has been pushed to the iOS device.
162
  1. Tap More Details.
169
  1. Tap Cisco Umbrella DNS Proxy.
    Notice the App: com.cisco.ciscosecurity
    The Provider Bundle: com.cisco.ciscosecurity.CiscoUmbrella
    These indicate that the profile is working correctly.
169 169
  1. Navigate back to Meraki Management and click Restrictions.
169
  1. Click Web content filter.
169
  1. Click Web content filter.
    Notice the Plugin Bundle ID com.cisco.ciscosecurity. This indicates that the profile is working correctly.
169

Verify Umbrella

  1. In the Cisco Security app, tap Status.
169
  1. Tap Protected by Umbrella.
    CSC lists connection details.
    Note: IPv6 is listed as Unprotected because this device does not have an IPv6 address.
169

Verify Clarity

Cisco Security App

  1. In the Cisco Security app, tap Status.
169
  1. Tap Protected by Clarity.
    The CSUC list connection details.
    Note: If CSC is enabled and registered, but not connected, generate some new web traffic and try again.
169

Upgrade the Cisco Security Connector

When an updated version of the Cisco Security Connector is available it will be pushed to the App Store and updated from there.

Uninstall the Cisco Security Connector

For information about removing apps from managed devices, see Meraki SM's documentation.


Meraki Registration < Verifying Umbrella with Meraki > Meraki Documentation